Smart UV power supply is an indispensable combination of various electronic facilities. Its function has a negligible response to the entire electronic details. At present, in various meters and details, the voltage source of the active voltage input is widely selected. . The CPU adopts a single-chip microcomputer, and the programming voltage adopts a 14-bit D/A converter; for the convenience of computer control and composition, the GPIB interface is increased, which is composed of a shared control chip and interface conversion channel output.
Intelligent UV power supply has the advantages of low ripple and precision of voltage regulation in linear power supply. The above distinction is divided into three overalls: main ring, auxiliary path, and cover path. The intelligent UV power supply can be used as a power input or an electronic load for an external power supply. The maximum output voltage is 50V, the maximum direct current is 2A, the maximum voltage is 3mV, and the maximum direct current is 012mA.
As long as you dispatch the smart UV power dispatch button, the input DC power will change and the input voltage will change accordingly. This is the precise method.
1. There are two situations: voltage and no direct current, and perhaps no direct current, so you should check whether the power load can be touched well, whether the load can be short-circuited or opened, and whether the load meets the standards.
2. When the smart UV power supply adjusts the voltage, the shipboard voltage adjustment does not go down. This is because the power supply consumes a small amount of direct current even if it is on the ship, and you turn off the smart UV power supply scheduling to zero, then there is no small amount of power. When the power was banished, the shipboard voltage did not rise until it was moved. Because the DC power dispatching was normally adjusted to a little bit above zero, the shipboard voltage could be adjusted down.
3. The smart UV power supply has voltage input, so there will be DC input if you want to adjust the voltage again, and the voltage will not be adjusted anymore. A series of results have been entered. The agency may be because the operator did not know too much about the constant voltage, The concept of constant current is caused; simply, if the constant current light is on, it indicates that the power supply is in constant current mode, and the input voltage is not adjusted at that time, but is determined by the load.
