During the use of the UV power supply, if rough adjustment is required, disconnect the load before the output voltage is adjusted to the required value, and then connect the load.
According to the required voltage, the UV power supply first adjusts the coarse adjustment knob, and then gradually adjusts the fine adjustment knob to achieve the correct fit. For example, when 12V voltage is necessary, the coarse adjustment knob should be placed on the 15V gear, then the fine adjustment knob should be adjusted to 12V, and the coarse adjustment knob should not be placed on the 10V gear. Otherwise, the maximum output voltage is lower than 12V.
Adjust the required voltage, and then connect to the load.
During the use of UV power supply, due to load short circuit or overload protection, the load should be disconnected first, then press the recovery button, and then turn on the UV power supply. The voltage can be restored to normal operation, and the load should be connected after the fault is removed.
When different rated current UV power supply series are used in series, the output current is the smallest rated value.
Each UV power supply has a watch head. When A/V is in different countries, it indicates the output current or the output voltage of the circuit respectively. It is usually placed in the voltage indication state.
Each circuit has two red and black output terminals. The red terminal represents +, and the black terminal represents-black terminal. There is an earth symbol in the middle of the panel, indicating that the terminal is connected to the chassis and is not electrically connected to the output. Each road is only used as a safety line. It is usually assumed that the earth symbol represents grounding, and +-means that both positive and negative power outputs are provided to the dual power amplifier.
The two-wire voltage of UV power supply can be used in series. This is absolutely not allowed to be used in parallel, UV power supply devices, so it is not allowed to short-circuit the output terminal for a long time.





